论文标题
直立变质GA0.37IN0.63P/GA0.83IN0.17AS/GE三连接太阳能电池的温度加速生命测试和失败分析
Temperature Accelerated Life Test and Failure Analysis on Upright Metamorphic Ga0.37In0.63P/Ga0.83In0.17As/Ge Triple Junction Solar Cells
论文作者
论文摘要
已经进行了直立变质GA0.37IN0.63P/GA0.83IN0.17AS/GE三连接太阳能电池的温度加速生命测试。加速度已通过使太阳能电池的温度(125、145和165°C)高于集中器内部的标称工作温度(90°C)(90°C)而实现,而在黑暗中注入电流,则模仿名义光电(500太阳)。故障分布已安装在Arrhenius-Weibull模型中,导致活化能为1.39 eV。因此,确定了像图森(Tucson)(美国亚利桑那州)这样的太阳能电池的72年保修时间。 ALT之后,为了确定失败的起源而进行了激烈的表征运动。我们已经检测到,仅温度浸泡足以通过增加泄漏电流,串联电阻和重组电流来降低细胞性能。当太阳能电池还向前偏向串联电阻的增加,并检测到短路电流的降低。失败分析表明:a)几种金属化亚产品集中在前金属网格的几个区域中,它们会毒害银,从而降低了金属薄板的耐药性两倍。 b)金属/盖层界面大大降解,并且盖层结晶质量的恶化,产生了特定前触点电阻的巨大增加,c)短路电流的下降主要是由于Gainp Top Top Subcell降解。
A temperature accelerated life test on Upright Metamorphic Ga0.37In0.63P/Ga0.83In0.17As/Ge triple-junction solar cells has been carried out. The acceleration has been accomplished by subjecting the solar cells to temperatures (125, 145 and 165°C) significantly higher than the nominal working temperature inside a concentrator (90°C), while the nominal photo-current (500 suns) has been emulated by injecting current in darkness. The failure distributions have been fitted to an Arrhenius-Weibull model resulting in an activation energy of 1.39 eV. Accordingly, a 72 years warranty time for those solar cells for a place like Tucson (AZ, USA), was determined. After the ALT, an intense characterization campaign has been carried out in order to determine the failure origin. We have detected that temperature soak alone is enough to degrade the cell performance by increasing the leakage currents, the series resistance, and the recombination currents. When solar cells were also forward biased an increase of series resistance together with a reduction of short circuit current is detected. The failure analysis shows that: a) several metallization sub-products concentrate in several regions of front metal grid where they poison the silver, resulting in a two times reduction of the metal sheet resistance; b) the metal/cap layer interface is greatly degraded and there is also a deterioration of the cap layer crystalline quality producing a huge increase of the specific front contact resistance, c) the decrease of short circuit current is mainly due to the GaInP top subcell degradation.